|
This car has a wheelbase of 203" and requires a driver no taller than about 5'10" and 170 lbs. In this case smaller is better.
It has an injected SBC that was built for the NEII index class. it consistently runs 8.50s
It has bowtie heads done by McKray, CP 11:1 pistons, Isky roller, Crower injectors that were just gone through by Ron's Fuel Injection in Tucson.
Spare parts include a shorty glide that needs to be gone through, 4:56 gear set, extra FI pump,
a short block with 14:1 pistons a bit more cam which makes it 3 to 4 tenths quicker than the motor in the car, and quite a bit of miscellaneous stuff.
The chassis certification is good until April of '08.
The car has an enclosed trailer (pictured below) with cabinets, electric winch, and electric tongue jack, and I just had 4 brand new tires put on it.
I also have a one year old SFI Simpson fire suit, Computech RaceAir Pro and lots of tuning data.
This makes the package pretty much ready to go race. Except for a couple of certifications the car could run this afternoon.
an extremely good value at $22,500.00 and race next week.
***************************************************
Robert Stirling: Racecars and Cars for Sale! (831)241-3373
Robert Stirling is again building dragster/ funnycar chassis if your on the west coast we recommend calling him now!
***************************************************
Are you are in the Midwest area?
building dragsters /funny cars is
Keith Burgin at: (317) 852-4547
Rooman motorsports
464 Johnson lane suite B
Brownsburg Indiana 46112
***************************************************
2004 Ueyhara chassis 225" wheelbase motor out 41"
a minimum weight car.
full magnesium body
fresh paint
beadlock wheels
fire system
seatbelts
chutes
full floater rear-end /carbon brakes
-as nice as it gets has run 5.70-265mph making it one of the fastest cars in the country.
sold less motor transmission , -a complete roller -realistically priced at - $19,500.00 , (would cost 40K +to duplicate.)
*clutch can and air jacks are available for this car as well.
***************************************************
Heavy duty Chaparral trailer!
measurements:
rear door opening 71" wide 66" high
inside bottom length 22'
Could use tires and tlc ,
no generator or compressor, some history here! - $ 5,000.00
Contact Performance Motorsports for more info...
***************************************************
Trailer For Sale $ 8,500.00
38 feet long, with a door on each side , full cabinets , generator and compressor, ready to race!
TRAILER SPECS:
It has a wench for the back door, a compressor, water tank and a generator.
It has bench space and cabinets.
It has been parked for 3 years. Needs 2 12 volt batteries.
It has a engine hoist and rail system out the side door
Do you want the best in front engine dragster
sales, service and performance?
Then call Robert Stirling at Stirling Racecars!
Call (831)422-2083
c
Steve Davidson Designs
Custom Metal Fabrication
Complete racecar fabrication
Complete aluminum work
Steve Davidson
(831)261-1690
***************************************************
FOR SALE
NEW! Big Block Chevy 427 standard deck 9.800
4 bolt mains with eagle steel caps
G.M. forged steel crankshaft 3.760 stroke Velasco cut .010/.010
Billet Engle roller camshaft
Crower roller lifters
Venolia rods
Venolia coated pistons 8.9-1 compression with 2 extra pistons -4.250 bore
Pete jackson comp gear drive ,
Weiand front cover
Enderle Billet fuel pump extension
RCD crank hub
ARP bolts and Studs throuout
melling HV oil pump with mods
milodon pickup
chrome oil pan 10qt
Dart Iron eagle heads
Manley stainless valves .
100 long Manely springs
Manley retainers,pushrods
Dart valve covers
littlefield blower manifold with burst panel installed
and port nozzels drilled.
Complete 8 MM blower drive with pulleys belt and idler assy.all new !
6-71 blower shop supercharger with 4" snout
Enderle birdcatcher
$ 12,500.00
All parts new and ready to run ,this could be run on gas ...
or with a little tuning could be run on alcohol and is capable of the 1000-1200 horsepower range
making this an excellent 7.60 nostalgia eliminator motor,it could be modified to run as a cackelfest motor as well!
***************************************************
NEW! The all new Enderle SHORT and Ugly!
A full 2-1/2 shorter than the famous big and ugly,
but with all the full flow features of a modern fuel injector --
this is especially handy where visibility is an issue-Available with a progressive butterfly option!
Bare injector with shaft and butterflies,
$1,365.00 complete... with metering valve linkage all lines and nozzles
$1,760.00
***************************************************
CARS/TRUCKS FOR SALE
|
1976 GMC 1 ton Dually Aprox. 15K since gone through. Rebuilt 454 (steel crank, rods, forged pistons, closed chamber oval port heads, alum. intake, shorty headers, and more) and T-400 trans. (extra plate and shift kit, heavy duty converter), front/rear suspension, drive shaft and lowered 3"(has air bags in rear for extra weight), Brakes all the way around with new drums including Hydroboost unit, 2.5" exhaust, converted to serpentine belt system, A/C system, etc. Interior done about 15K ago and in great shape. Full stereo system with remote,12 disc CD player, a 100 watt amp, and 4 6x9 speakers, Windows tinted, Painted 2 yrs. ago with all new weather stripping, handles, mirrors, bumpers, all trim, and a new cowl hood. Has standard hitch to tow a enclosed car trailer or ?.Basically a new truck. Aprox. 45K invested in truck.
Asking $12,000K. Please call 916-624-0185 (ask for Chris)
|
|
 1934 FORD 
|
This cars has less than 3000 miles on this 1934 Ford :
Deuce Customs fiberglass body
SAC chassis
427 bb chevy 390hp
Th 400 with shift kit
9" rear-end
Polished American wheels
Tinted glass, power window Independent front end
Rack & pinion steering, tilt column
Vintage Air AC blows like an icebox (car currently in Vegas )
Pioneer stereo CD player
4 wheel polished disc brakes
Coated exhaust system
Heidt polished stainless
Lots of chrome
PPG paint
Aluminum radiator
trick interior
trick grill insert - ($2800.00)
This car has parts investment of $79,000 with over 350 man hours
of labor involved. A very trick
reliable car with tons of creature
comfort features.
Realistically priced at $79,000.00
(transportation available)
|
Stirling, rear engine dragster 230" 9" floater
Last ran as TAD floater rear end complete with center section.
Great starter care----------------- $6,000.00
|
